‫So now we're on the last year to fix the problems and run Carly.
‫Now, in this lecture, I will assume that you do have trouble with network connections, and I'm going
‫to give you some solutions so that you can fix the problem.
‫Now, hopefully, you're not facing such a problem, so if you don't have a network situation, please,
‫you don't have to apply any of these solutions in this lesson, but it's good to have you on the ride
‫and you can always sharpen your troubleshooting skills.
‫So first off, this reboot, the machine to understand whether the problem is an exception for the initial
‫run or not.
‫So I shut down the virtual machine because I want to look at the settings of it now, select Carly and
‫click the Settings button and click this system tab.
‫I want to make the RAM three gigabytes.
‫So now I can click the Start button to boot it again.
‫Username and password are both Kelly.
‫OK.
‫We are in again.
‫So let's check the network connection by clicking the network icon at the upper right hand corner.
‫So I think there's a problem on the DHP of the VMworld.
‫Well, anyway, we can live without DHP as well.
‫So I'm looking at the wired network.
‫Don't be confused.
‫Even though you share the wireless connection of your host machine, it's simulated as a wired network
‫in the VM.
‫So let's open a terminal screen and look at the networking service if it's running right service networking
‫and press tab twice to see the available commands of the service.
‫Networking service does not have status command, so I'll assume that it's not started and try to start
‫it.
‫And if you are still not connected at this point, let's go to network settings.
‫You can go to network settings via advanced network settings under the menu.
‫Or you can right click on the network icon in the upper right corner and select edit connections.
‫Now, click the wheel icon under the Wire tab, OK, OK, go to the IPv4 tab to set the IP manually
‫click the manual option.
‫I'll choose an IP for the new column.
‫Now, the IP block of my virtual network is 10.0 Dot to zero through 24.
‫So I'll choose an IP from this block netmask is 255.255.255.0 for 24 IP block.
‫The Gateway is 10.0, not 2.2.
‫So I can use a Google DNS as my DNS server and round.
‫Now you can click the same one.
‫OK, I'll reboot the machine to be sure that the changes are applied.
‫Completed.
‫So open the terminal screen and first type pseudo asks you to switch the user to route so that you don't
‫have to write pseudo for every command that requires privileges and then run the if config command to
‫see the IP address of county.
‫And it's 200.
‫So let's ping a remote system, for example, Google DNS eight, eight eight eight eight eight.
‫Yes, we received the response packages, and that works OK now, so to double check.
‫Open a browser and visit any web site.